Overview and explaination of the Port-Based NAC section
An explaination about Network Access Rules
An extension to Network Access Rules
If a company has more than one site, there are a few different solutions to prevent problems with the VLAN.
Usually following steps are required to activate dot1x / RADIUS authentication on your switch.
Cisco SG Configuration
Cisco Catalyst Configuration
HP Procurve Configuration
Dell Powerswitch Serie N Configuration
HP Aruba Configuration
Test Cases to try
Troubleshooting
Disaster Recovery
Overview ans explaination of the Network Documentation
Inquiries to the switch are documented under Authentication Reports.
If you subscribe to PNAC, it is possible to receive a Radius server from HS2N. It is recommended to have at least two radius server in a company, in case one fails.
This displays a list of devices that are not on the network.
In oder to use SNMP on XEOX you have to do the following:
After you have defined your permanent cabling, you can connect Network Devices like Switches to the cabling.