IP Plan

IP Plan Module

To start with the IP Plan, you have to enter your Subnets. Press Create Subnet in the Module IP Plan - Subnet.

new subnet

Common Fields:

  • Subnet Name: e.g. Office, Home, Server, ...
  • Subnet: IPv4 Subnet like 192.168.1.0
  • CIDR: How many Bits are your subnet width? e.g. 24 Bits for a 255.255.255.0 Netmask
  • Default Gatway: Optional for the Visualization.

After you have entered the Subnet, you will see an overview of used IP addresses in the subnet.

Example

Legend:

  • IP in Green: The hardware (IP address) is online
  • IP in Blue: The Agent has reported the IP recently
  • IP in Gray: The hardware has been created manually. e.g. none Windows Machine
  • IP in Red: The hardware has been offline for a while. Probably the hardware doesn't exists any more. So don't trust the IP address since it could be outdated.
  • IP in Black: Default Gateway
  • Dark gray background: This IP is covered by a DHCP scope

DHCP Scope

Here you can enter DHCP Scopes. This information will be used in the IP Plan only for visualization. You can also exclude ranges.

Firewall

Here you can document your Firewall.

Firewall new rule

Fields:

  • Source IP: external IP
  • Destination IP: internal IP
  • TCP Ports: Comma separated list of open Ports.

The information from the Firewall will be used in the Module IP Scan and in the IP Plan.

DNS

Here you can document your (public) DNS infrastructure. e.g. external Servers. This information is required for Certificate checks in case you are using the Module IP Scan. Also the DNS Information will be used for the IP Plan.

Subnet Values for Software Rollout

When creating subnets you have the possibility to add Configuration variables which can be referenced in some Job actions.

Subnet Configuration

To use the configuration variables, the following syntax must be used: $[Configuration name]

e.g.:


http://$nasip/$naspublicpath/install.exe

NAT/ACL

NAT describes the translation of network addresses behind and in front of the firewall, which is why the input and output IP address is specified here, as well as the port over which the connection runs.

NAT List

Create NAT